How to Connect Mevo to a WPA/WPA2 Enterprise Network

To join a WPA/WPA2 Enterprise Wi-Fi Network, first make sure that Bluetooth and Wi-Fi are enabled on your iOS device.

Launch the Mevo app. On the bottom right of the card, tap the 'Configure Mevo' button.

Tap 'Show WiFi Networks (Disable Mevo Hotspot).'

You will see a Loading wheel, and then see the following screen. Your available networks should populate in a list. 

Note: There may be a short delay for your app to update when changing your Mevo connection settings. Please be patient for a short moment after making changes to your Mevo connectivity.

Select the network to join on your network list.

If the network you selected was an Enterprise network, you should now see this screen asking for your Enterprise network details.

Enter the username and password of the network provided to you by your network/IT administrator.

Then, change the Mode and Phase 2 to match the settings of the Enterprise network you are connecting to (this should also be provided to you by your network/IT administrator).

After a moment, your Mevo will be connected to your network. This will also be indicated by the LED ring showing a solid green light above the bars icon on the back of the camera.

Tap 'Done,' and the Mevo card will update its status again for a moment.

It soon will then give you the option to connect to your Mevo. Tap 'Connect.'

However, the Mevo cannot connect to networks with captive portals. Generally speaking, these are networks that require authorization through a mobile browser, which the Mevo app does not have built in. They are common in hotels, convention centers, etc.